EDN (Ethernet Data Node)
Reliable, cost-effective DMX output for large Pharos Designer systems. Each unit has up to 20 fully-isolated and RDM-capable DMX512 outputs.
The configuration software Pharos Designer 2 is vailable for both Windows and Mac, it’s free to download from Pharos’ website.
Any further information, please contact us
The Pharos EDN (Ethernet Data Node) is a convenient and scalable solution, providing cost-effective Ethernet-distributed DMX ports for large control projects.
The EDN is an easily configurable networking node that is specifically designed to add physical DMX ports to Pharos Designer Controllers and integrates natively with the full Pharos Designer range.
- Extremely compact, it is available in either a 10 or 20 port unit, both coming in a 1U 19” form factor
- For higher port count installations, nodes can be daisy-chained to provide as many physical DMX ports as you need.
EDNs are discoverable through Pharos Designer 2 software and associated to a Pharos Designer Controller to be seamlessly configured as part of your patch. Ports can be flexibly assigned to any Controller in your project providing an elegant data distribution solution over an Ethernet network with minimal setup required.
Specifications
Certifications
CE compliant, ETL/cETL compliant and California Title 20/24 compliant.
Power
100-240VAC / 50-60HZ / 0.25-0.1A
25W typical (30W maximum)
IEC connector with switch *
* Power cable not supplied
Required
Any Pharos Controller
Configuration
Pharos Designer 2.7 or later (EDN 20)
Pharos Designer 2.8 or later (EDN 10)
Addressing
By rotary selector switch
Temperature
0°C to 50°C (32°F to 122°F)
Humidity
10-50% relative, non-condensing
Ingress
IP40
Protection
Self-healing ports can withstand continuous AC voltage up to 300V or peak impulse voltage up to 650V with duration less than 10ms
Isolation
Ports independently galvanically-isolated up to 2kV
Physical
19″ rack unit, 1U, 7.2″ deep
Weight
1.6 kg (3.5 lbs)
Shipping
57 x 45 x 18 cm (22″ x 18″ x 7″)
3.2 kg (7 lbs)
Recovery
Hardware watchdog and recessed reset button
Warranty
5 years
Interfaces
Ethernet
Two Neutrik etherCon (RJ45 compatible) for 100*/1000 Base-TX Ethernet with Link/Data LEDs; Static IP or DHCP
* From Designer v2.8
Note: LPC 1/2/4 & TPCs support 10/100Base-TX.
DMX
Ten (EDN 10) / Twenty (EDN 20) DMX512 ports, RDM compatible **
** Install-friendly 0.200″ (5.08mm) plug in rising clamp connectors (included)
Protocols
DMX
DMX512 (512 channels each) in DMX mode
RDM
Supports discovery and addressing via Designer Software
UltraDMX
MY94441 supported natively
SPI
In SDI mode, supports serial data via the Pharos SDI
Note: one output protocol per EDN
Produits connexes
-
SDI (Serial Data Interface)
The Pharos SDI is an accessory to the Pharos EDN (Ethernet Data Node). Together they enable any controller in the Pharos Designer range to output a variety of serial protocols for controlling products such as addressable LED tape.
The configuration software Pharos Designer 2 is vailable for both Windows and Mac, it’s free to download from Pharos’ website.